| Content |
| Architecture |
Single-ended (SE) mode: 4 x 4
Bridge (BTL and PBTL) modes: 4 x 3, 4 x 2 or 4 x 1 |
| Output Power |
4 x 640 W at 4 ohms (SE)
4 x 360 W at 8 ohms (SE)
2 x 1260 W at 8 ohms (BTL)
1 x 2550 W at 4 ohms (PBTL) |
| Power supply |
Universal SMPS with PFC |
| Inputs |
Milan-AVB, AES/EBU, Analog |
| Network |
Milan-certified with seamless network redundancy |
|
Ισχύς Εξόδου: 4x 400W RMS /8Ω - 4x 300W RMS /4Ω - 2x 600W RMS /8Ω
4x 400W RMS 70/100V - 2x 800W RMS 140/200V
Παραμόρφωση: THD 20Hz-20.000Hz στο 1W 0,1%
Απόκριση Συχνότητας: 6,8Hz - 34Hz
Λόγος Σήματος / Θόρυβο: 112dBA
Class TD-F: ρυθμιζόμενο Switch Mode, PSU
Hi-Z: 70V/100V έξοδος ανά κανάλι
Δυνατότητα Bridge-Mode
Δυνατότητα Λειτουργίας με τάση 130 - 265V
Προστασία AFS, VHF, Θερμική, DC, RFI, Υπέρτασης, Βραχυκυκλώματος
2xRJ45 EtherCon σύνδεση για Έλεγχο του ενισχυτή με το σύστημα NomadLink Network με τη βοήθεια Υπολογιστή ή με το NLB 60E
Διαστάσεις / Βάρος: 483x88x343 mm / 12kg
|
POWER AMPLIFIER 4 X 2100 WATT / 4Ω
Παραµόρφωση: THD 20Ηz - 20ΚΗz στο 1W 112d ΒΑ
Class TD µε Ρυθµιζόµενο Switch Mode R.SMPS
VPL Voltage Peak Output Ρύθµιση Bridge-mode,
∆υνατότητα λειτουργίας µε τάση 130 - 260Volt,
Προστασία: AFS, VHF, Θερµική, DC, RFI, Υπέρτασης, Βραχυκυκλώµατος,
Ανοιχτού Φορτίου
2xRJ45 EtherCon Σύνδεση για έλεγχο µε υπολογιστή µε το σύστηµα
NomadLink Network ή µε το NLB 60Ε
Ισχύς Εξόδου: 4x1300W RMS /8Ω - 4x2100W RMS /4Ω -
4x2500W RMS /2Ω
2x4200W RMS /8Ω - 2x5000W RMS /4Ω
∆ιαστάσεις / Βάρος: 483x88x396mm / 12kg
Very high power and channel density – • The four-channel FP
10000Q delivers a total of 10000 W (4 x 2500 W @ 2 ohms) in
only 2U
Four-channel fexibility – • Four channels in one cabinet increases
effciency, fexibility and value in powering monitor systems, line
arrays, and bi- or tri-amped systems. Adjacent channels bridgeable
for 2- or 3-channel operation
Lab.gruppen sound quality – • FP 10000Q amplifers maintain
the impeccable sonic performance standards set by the original fP
Series, with the same durability and even greater effciency
NomadLink • ® network ready – Monitoring and control of key
functions accessible via the intuitive DeviceControl software and
the robust, daisy-chained NomadLink® network
Patented Class TD amplifer topology – • Road-proven output
stage delivers Class B audio quality with Class D effciency
Regulated Switch Mode Power Supply (R.SMPS) – • Output
power remains constant even with signifcant drops in the mains
voltage
Effcient cooling system – • Unique, lightweight Intercooler® cop-
per cooling system dissipates more heat to allow extended peak
output
Adjustable parameters – • Selectable Gain, scalable Voltage Peak
Limiter (VPL), and bridge-mode operation allow custom confgura-
tion for any system or application
XLR input connectors •
Heavy-duty binding post or Speakon output connectors •
Comprehensive protection and warning – • Excessive output
current, DC, high temperature, very high frequency (VHF), short
circuit, open load, mains fuse protection, and soft start
|
Τελικός ενισχυτής 4X120W/4Ω, 4X80W/8Ω, bridged 240W/8Ω (Μono), είσοδοι combination jack balanced, απόκριση συχνότητας 20Hz-50 kHz, S/N 105dB, 2U. Κατάλληλος για εγκαταστάσεις & P.A. 15,5kg.
Power Output Level: QD4480
8ohm (Quad Ch) 80W
4ohm (Quad Ch) 120W
8ohm bridged mono 240W
Input Sensitivity (8ohm, 1kHz) 0.775Vrms
Input Impedance 20kohm Balanced
Slew Rate (8ohm, Full Swing) ±30V/?sec
Frequency Response (±0.5dB) 20kHz ~ 50kHz
T.H.D. (f=20Hz~20kHz, Half Power) 0.03%
Signal to Noise Ratio 105dB
Damping Factor (8ohm, 1kHz) 100
Rasidual Noise -85dB
Channel Separation (8ohm, 1kHz) 80dB
Voltage Gain (4ohm) 26dB 29dB 32dB
Power Source 100-120VAC or 220-240VAC ; 50/60Hz
(supplied AC mains transformer depends on country requirements)
Power Consumption 300W 420W 770W
Weight 11.5kg/25.3lb 15.5kg/34.2lb 17kg/37.5lb
Dimensions 482(W) x 88(H) x 369(D) mm
/19(W) x 3.5(H) x 14.5(D) in
|
Τελικός ενισχυτής 4x75W/8Ω. Ευαισθησία 1.4V -
Απόκριση συχνότητας (at 1W into 4/8 ohms) ±
0.5Db-Crosstalk (below rated power 20Hz to
1kHz) > 70dB S/N110dB-THD 55dB, typically
> 70dB. Διαστασεις: 1.75" x 19" x 14.25“.
Κατάλληλος για μόνιμες εγκαταστάσεις, 1U rack.
Βάρος 4,5kg.
|
The new DEEP2 amp series features four class-H power amplifiers with toroidal core offering amplifying levels from 2 x 400 W till 2 x 810 W at 4 Ohm. During the development of this series we attached a great importance to the reliability and the durability of the amps in continuous operation, this is why we used exclusively high end and selected components for the construction of these products.
The DEEP2 series features a Clip Limiter as well as every common protection circuit. On the rear panel you will find all the common In- and Outputs.
The DEEP2 series will convince every user thanks to a dynamic and very clear sound which is perfectly adapted for Subbass applications as well as for multifunctional speakers. All models are lightweight and feature a robust steel plate housing and a very user friendly and compact design.
The DEEP2 series will prove to be a profitable and reliable choice for bands, renting companies and professional users thanks to its excellent price/performance ratio.
Product type
Power Amplifiers
Rated ouput power (1kHz @ 4 Ohms)
4 x 810 W
Rated ouput power (1kHz @ 8 Ohms)
4 x 490 W
Rated ouput power (1kHz @ 8 Ohms, bridged)
2 x 1600 W
Frequency response
20 - 20000 Hz
Total Harmonic Distortion (THD)
< 0.1 %
Signal-to-noise ratio
105 dB
Input sensitivity
0.775 V
Protection circuits
DC protection , short circuit , thermal overload
Controls
4 x volume , bridge/stereo mode selector , ground lift , mains switch (on/off)
Indicators
Limit , Power , Protect (protection circuit engaged) , Signal
Speaker output connections
Speakon compatible
Cooling
highly efficient, automatic
Operating voltage
transformer
Operating voltage
230 V AC / 50-60 Hz
|
€ 
£ 
$ 
kr. 
kr 
kr 
CHF 
лв. 
рсд 
zł 
Ft 
lei 
Kč 
ден 
L 
Αξιολογήσεις
Δεν υπάρχει καμία αξιολόγηση ακόμη.